Diagram SOlution

Showing posts with label 2. Show all posts

Friday, September 26, 2014

Simple 2 Watt Small Switching Power Supply Circuit Diagram

In this small switching power supply, a Schmitt trigger oscillator is used to drive a switching transistor that supplies current to a small inductor. Energy is stored in the inductor while the transistor is on, and released into the load circuit when the transistor switches off.

2 Watt Small Switching Power Supply Circuit Diagram

The output voltage is dependent on the load resistance and is limited by a zener diode that stops the oscillator when the voltage reaches about 14 volts. Higher or lower voltages can be obtained by adjusting the voltage divider that feeds the zener diode. The efficiency is about 80% using a high Q inductor.

How to connect LCD Display on the Arduino using only 2 pins

Generally for connecting an LCD display to an Arduino using 7 strands, it usually breaks the leg that has any projects that remain few ports to be used. But there is a way, using an IC 74LS164 (8-bit serial shift register), a resistor and a diode, but its not just hardware, you have to use a library.

This Arduino library for connection of 2-wire or 3-wire using HD44780 compatible LCD display via shiftregisters. This circuit is considered "deprecated", but its worth testing.

LCD Display on the Arduino Circuit

Thursday, December 12, 2013

TDA2005 2 X 20 Watt Power Amplifier

This time, there is a series of audio amplifer 20W as well, but using IC TDA 2005 as a series of his base amplifier.
The series of 2x20 Watt Audio Power Amplifier using TDA2005 can you see in the picture below.

Technical Data:

Performance of TDA2005M: (for this circuit); At 4.14 V supply voltage: 2 x 20 watts (stereo) into 4 Ohms.

Distortion: Approx. 0.2% at 4 Watts into 4 ohm load.

Frequency Range: Approx. 20 Hz to 22 KHz.

Input Sensitivity: Approx. maximum 150 mV rms. .

Power supply: + 8 to 18 volts, approx. 3.5 Amps maximum per channel.

Monday, November 25, 2013

Fuse Failure Alarm 2 LED

This circuit motivation let somebody see the performance of the equipment,otherwise Check the fuse arrived the circuit.The circuit is insignificant and the power supply voltage of all kinds. It parade with LED, 2-color in single. Which is cathode normal kind,the anode has two separate terminals. If the circuit is functioning accurately LED, it exposed in environmentally friendly colour.

The display is red, at what time the fuse voguish the circuit is damaged.The resistor R1 limits the current to stream through the LED is going on for 2 mA.This is a sufficient amount to do the LED light.If it lowers the R1 down, the LED light up. In the regular action of the circuit and The fuse is not damaged. The zener diode to prevent the green and red LED light up at once.Zener diode prevents the LED is sea green and red illumination at the same time. The high-pitched efficiency LED, whilst connected in the sphere of congruence. The red LED uses high-pressure, so with the intention of single green LED illumination up only. Diodes D3 and D4 command prevent perilous in support of the LED. While the semi cycle denial voltage of the alternating current voltage.However, if the DC supply voltage.I perform not include to application diode protection.